www.panda4x4.info

Hello, I´m Sérgio Ferreira from Portugal and I'm a owner of a 1988 Panda 4x4 Sisley Mark I.

I've been searching your forum for a diferencial lock for the rear axle and I'm a bit confused.

Which brand supply the lock's? K.I.K. transtad, and I've seen another one but I don't remember right now.

Which one do you recomend?

I tried to translate this at google:

topic.asp?TOPIC_ID=21&whichpage=1

but it's quite dificult to understand.

Can you please help me?

Thank You

... right, Techno-sea is a new name of KIK brand, Transtad product is the same .... just the name (and probabily the cost) is different!


...call the number posted by carlo and ask of Sig. Giuseppe ..... and remember it that you call in name of the PANDA4x4.info forum ... for special price ....


excuse me for bad english ...
[:I]

the new brand is

Techno Sea

via dell Industria 6, Calderara di Reno, BOLOGNA 40012

phone number: 051727841

Techno Sea
via dell Industria n. 6
40012 Calderara di Reno (Bologna)
-ITALY-

Hello Sergio, you can phone at number 0039 051 727841. By asking for Mr Giuseppe shall not forget to introduce yourself as a Panda4x4.info forum member to get some discount on standard price

Panda international!

Per Dio....[:o)][:o)][:o)]

Yes.....We can!

Welcome to the forum Madeirense,
Italian products Kik "differencial the Look" are very strong and you are good with them
regards

yes!!!

Thank you for your answers on such short notice.

I haven't replied yet because I was away for the weekend...

I will reach this man by phone as son as I can.

Other thing, can you please explain me what is the "mozzi liberi" (i think you write it like this) is some type of "overdrive"?

Thank you once again...

Hi Maider, "mozzi liberi" are the FREE WHEELING HUBS for rear axle. Latest Panda 4x4 Mark I was equipped directly with manual coupling MOZZI LIBERI, the Autobianchi Y10 4x4 was set up with a lowering air pressure coupling system

The Y10 4x4 rear axle fits very well on a Panda, the coupling control can be easly settled inside (using wire cables similar to parking brakes) to make a finest upgrade

The hubs with manual coupling control
Immagine:

[font size="1"] 131,93 KB[/font id="size1"]

Ok, now I understand...

You fit the rear axle of an Y10 4wd to a panda and the use a hand-made coupling device...

It's very nice indeed...

By the way, do you know if this company (techno sea) has an e-mail adress?

The email address I do not know,
but these are the phone numbers 0039 051 727718 FAX 0030 051 727370